MobilSat MSP-C Manual do Utilizador descarregar pdf (Página 14)

Manual Location (Disabled)

Disabled

When Manual Location is disabled the D3 reads the Location values

(Latitude and Longitude) from the GPS module installed on the

Mount/UCB.

NOTE: If a Search has been initiated and it has been 3 minutes with GPS

not acquiring valid latitude and longitude, the D3 will use the current

values displayed in Latitude and Longitude and begin a search for the

target satellite. These values may be from a previous location and not

valid for Skew and Ranging information in some modems.

Enabled

When Enabled the D3 Controller will use the current Latitude and

Longitude values located in the Latitude and Longitude fields.

Latitude

Latitude values can be entered manually if GPS is not able to deliver valid

data to this field. But even if Manual Location has been Enabled once

GPS can deliver a valid Latitude it will overwrite the current value in this

field.

Longitude

Longitude values can be entered manually if GPS is not able to deliver

valid data to this field. But even if Manual Location has been Enabled

once GPS can deliver a valid Longitude it will overwrite the current value

in this field.

Azimuth Origin (2.5)

After a Dish Calibrate the D3 will set Azimuth Origin on an F1 to 0 (zero)

degrees. On an F2, F3 and XF mounts this value is set for about 2.5

degrees.

The primary reason for Azimuth Origin on the F2 and F3 is to allow the

dealer to set the mechanical Azimuth Stow location to a true physical

Azimuth Zero position relative to the mounting plate. Even though this

1 2 ... 9 10 11 12 13 14 15 16 17 18

Sem comentários

MobilSat MSP-C Manual do Utilizador Página 14